Zasobnik kablowy telekomunikacyjny ZKM

Cable enclosures are widely used in telecommunication networks, installed along cable routes as well as at their endpoints. They are designed for storing excess telecommunication cables laid in cable ducts and serve as trunk lines, branching points, and junctions for all telecommunication cables.

The installation of a cable enclosure can take place virtually anywhere along the cable duct route. Typically, it is covered with a layer of soil, usually with a standard height of 0.7 meters or more. However, there is also the option to install the enclosure directly at ground level, where the cover is flush with the ground surface.

Thanks to the enclosure, it is possible to hermetically introduce cable ducts using an additional U32 or U40 seal, as well as safely pull telecommunication cables and lay cable reserves along with junction covers.

Before burying the enclosure, it is recommended to cover it with a foil sheet, protruding at least 200 mm beyond its outline. Additionally, segments of warning tape, used in the specific cable duct, should be laid on the foil to provide additional protection.

Cable enclosures have the form of a vertical box with a round hatch and consist of a body, an inner reinforcing tube, and a gasket. There is also the possibility of equipping the enclosure with places for a junction sleeve.

Both the body and cover of the enclosure are made as monolithic castings using rotational molding technology. The polyethylene supporting tube is supplied externally by an external company, while the gasket is produced to order by the VENKON company.

The cover of the enclosure has been designed according to the PN-EN 124:2000 standard for load transfer up to 15kN (A15 class). The body of the enclosure is responsible for transferring force from the cover and pressure from the surrounding soil. The enclosures are suitable for both pedestrian and vehicular traffic, as confirmed by strength test reports and the Centino CERT certificate.

The use of covers and hatches from other manufacturers is permissible provided they are geometrically compatible and meet the requirements of the PN-EN 124 standard and a minimum A15 class. Any additional loads not accounted for in the calculation reports should be taken into consideration by the designer.

The construction of the enclosure includes:

• Cover
• Body
• Gasket
• Supporting tube