Zaślepka ciśnieniowa do mikrorurki 12mm doziemna

Pressure end cap for microduct, direct burial – watertight and gastight, 18 bar

The pressure end cap for microduct is a reliable solution for sealing the ends of microducts in fiber optic and telecommunication networks. It is designed for installation in cable chambers and handholes, as well as directly in the ground. It protects the microduct against the ingress of water, gas and dust, so the installation remains dry, tight and ready for further expansion.

The end cap is reusable, so after removal it can be installed again, e.g. during cable blowing or network expansion. Installation and removal are quick and tool-free, which will be appreciated by field crews.

The end cap is equipped with a snap-in clip that prevents the tube from being accidentally pulled out. The material is resistant to substances found in cable ducts and in the ground, and the design is completely watertight and gastight.

Key features of the microduct end cap:

• Resistance to a pressure of 18 bar, for pressurized installations,
• Watertightness, protection against moisture and flooding,
• Gastightness, protection against gases penetrating the cable duct system,
• Dust-tightness, clean interior of the microduct,
• Tool-free operation, quick installation and removal,
• Reusable, economical and flexible,
• Snap-in clip that locks the tube against being pulled out,
• Resistance to chemical agents in the cable duct system and in the soil,
• Installation directly in the ground, without an additional enclosure.

Application:

Direct burial end caps for microducts are used in cable chambers, handholes and directly in the ground. They are well suited for the construction and expansion of FTTH networks, microduct systems and telecommunication infrastructure, wherever free ends of microducts must be permanently protected against water, gas and contamination.